TM 9-2320-366-20-4
Section II. MAINTENANCE PROCEDURES
This task covers:
a. Removal
d. Assembly
b. Disassembly
e. Installation
c. Cleaning/Inspection
f. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Materials/Parts
Engine shut down (TM 9-2320-366-10-1).
Grease, Automotive and Artillery (GAA) (Item 22,
Solvent, Dry Cleaning (Item 65, Appendix D)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Rag, Wiping (Item 50, Appendix D)
Wrench, Torque, 0-175 lb-ft (Item 58,
Spider, Universal Joint, Vehicular (Item 274.2,
Goggles, Industrial (Item 15, Appendix C)
Seal, Shaft (Item 271.2, Appendix G)
Hammer, Hand (Item 18, Appendix C)
Screw, Cap (8 per drive shaft) (Item 260.1, Appendix
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris. Failure to
comply may result in injury to personnel.
a. Removal.
NOTE
All drive shafts are removed the same
way. Front drive shaft shown.
There are two types of bearing cups,
those with tabs and those without.
Perform the following step on bearing
cups with tabs.
(1) Lift tabs from two bearing cups (1).
(1.1) Remove four screws (2) and two bearing cups (1)
from drive yoke (3). Discard screws.
(2) Slide drive shaft (4) from side to side and separate
universal joint (5) from drive yoke (3).
(3) Perform steps (1) and (2) on opposite end of drive
shaft (4).
Change 2
