TM 9-2320-366-20-4
NOTE
Perform the following step on bearing cups
with tabs.
(4) Lift tabs from two bearing cups (6).
(4.1) Remove four screws (7) and two bearing cups (6)
from drive shaft (4). Discard screws.
(5) Remove universal joint (5) from drive shaft (4).
(6) Remove two grease fittings (8) from universal joint
(5).
b. Disassembly.
CAUTION
Match mark spline plug to slip yoke to
prevent assembly out of phase or out of
balance. Failure to comply may result in
damage to equipment.
(1) Match mark spline plug (1) to slip yoke (2).
(2) Remove dust seal (3) from slip yoke (2).
(3) Remove slip yoke (2) from spline plug (1).
(4) Remove dust seal (3) from spline plug (1).
Discard dust seal.
Change 2
