TM 9-2320-260-34-1
9-4. TRANSFER REPAIR (Contd)
25.
Remove retaining washer (5) from rear sprag race (3) and place on top of front sprag race (1).
Holding together, turn retaining washer (5) and front sprag race (1).
26.
Place front sprag race (1) and retaining washer (5) over inner sprag race (2) turning counter-
clockwise as it passes over inner sprag race (2). The retaining washer (5) fits between front (4)
and rear (3) sprag races.
27.
Check that thin flange of retaining washer (5) is in contact with edges of front (1) and rear (3)
sprag races. Any gap indicates a sprag is not correctly seated.
Install second snapring (6) in upper groove of inner sprag race (2).
28.
Place sprag shifter shaft (8) in clutch fork (7) alining screw hole (12) of clutch fork (7) with screw
29.
hole (9) in sprag shifter shaft. (8).
Instill setscrew (10) in hole (9) of clutch fork (7) and into hole (9) in sprag shifter shaft (8). Tighten
30.
setscrew (10) 45-57 lb-ft (61-77 Nm).
Install new safety wire (11) through setscrew (10), wrap safety wire (11) around sprag shifter
31.
shaft (8), twist ends together, and cut off excess safety wire (11).
Bend twisted ends of new safety wire (11) to clear clutch fork (7) and around front of sprag shifter
32.
shaft (8).
9-38