TM 9-2320-260-34-1
9-4. TRANSFER REPAIR (Contd)
4. Gears (2) and splines (1) repair:
a. Remove raised edges of nicks on gear teeth or splines using a fine mill file or crocus cloth.
Do not remove extra metal to remove actual nick.
b. Minor scoring on press fit surfaces do not require repair.
c. Scoring on gear teeth in direction of tooth motion is not repairable. Replace gear.
d. Minor nicks and burrs on teeth of splines (1) are removed using a fine mill file held and moved
parallel to spline surface.
NOTE
Mated races and bearings must be replaced together.
5. If required to replace bearings (5) in front cover (3), remove snaprings (6), use bearing
remover/replacer to press out bearings (5) with mated races (4).
6. To replace bearings (9) in housing (7), use bearing remover/replacer to press out bearings (9)
and mated races (8).
9-34
