TM 9-2320-260-34-1
9-4. TRANSFER REPAIR (Contd)
NOTE
Correct positioning of sprags is stamped on edge of sprag race.
Both front and rear sprag races are assembled the same.
Coat all parts with OE/HDO 80/90 before assembly.
18.
Place one outer sprag race and gear (23) on flat surface with open face up.
19.
Lay one spring (20) inside sprag cavity on bottom of sprag race and gear (23).
20.
Position forty-one sprags (18) with lower notches (22) over spring (20) in sprag race and gear (23).
Ensure all sprags (18) are at same height.
21.
Carefully install second spring (20) in upper, notches (21) of sprags (18). Recheck that all sprags (18)
are at same height and points (19) face clockwise.
22.
Repeat steps 18 through 21 for second outer sprag race and gear (23).
23.
Place front output shaft (27) in soft-jawed vise with threaded end up. Ensure that lower snap-
ring (28) is firmly seated in groove on inner sprag race (26).
24.
Place retaining washer (24) on top of rear sprag race (25) and install on inner sprag race (26),
turning clockwise as it passes over inner sprag race (26). Rear sprag race (25) must seat against
lower snapring (28) in inner sprag race (26).
9-37