TM 9-2320-260-34-1
9-4. TRANSFER REPAIR (Contd)
NOTE
Keep all parts clean and protected from dust until installation.
gear oil at time of assembly.
Coat shafts and bores of gears with white carbonate pigment
prior to press type assembly. Remove excess carbonate pigment
after assembly and coat parts with OE/HDO 80/90 gear oil.
NOTE
Assistant will help with steps 1 through 3.
1. Using bearing remover/replacer, press bearing races (8) below edge of housing (7).
2. Using bearing remover/replacer, install new seal (11) in bore of cap (10).
3. Install snapnngs (6) in grooves of bores of front cover (3) and use bearing remover/replacer to press
in races (4) to seat against snaprings (6).
4. Install new seal (12) in shifter bore of front cover (3) with lip of seal (12) facing in.
5. Using bearing oil seal replacer, install new seal (14) in bearing retainer (13).
9-35