TM 9-2320-211-20
2-266. Heater Shutoff Valves
(2) Install the filter bowl, attach the clamp,
and secure the bowl with the clamp screw.
a. Removal.
(3) Open the heater shutoff valve.
(1) Disconnect the fuel line at the heater
2 - 2 6 5 . Fuel and Overflow Lines
shutoff valve.
(2) Unscrew the valve from the filter head.
a. Removal.
(1) Disconnect the fuel line union connectors
b. Installation.
at the heater.
(1) Screw the shutoff valve into the filter head.
(2) Remove the screws which attach the clips
(2) Connect the fuel line to the valve.
to the van front panels, and remove the clips.
2-267. Fuel Line Fittings and Fuel Tank
(3) Pull the lines down through the holes in the
Shutoff Valves
floor of the bonnet.
a. Removal. Loosen the nuts on each side of the
CAUTION
valve or fitting and remove the valve or fitting from
Do not make sharp bends in the lines.
the line.
b. Installation.
b. Installation. Install the valve or fitting bet-
(1) Push the lines up through the holes in the
ween the ends of the line, and tighten the nuts.
floor of the bonnet.
2-268. Bonnet Handles and Control Rods
(2) Secure the union connectors and heater,
a. Removal.
and bend the lines to fit if necessary.
(1) Working inside van, open the bonnet front
(3) Attach the clips holding the lines to the van
door with the bonnet front door control handles.
front panel with panhead screws.
(2) Working outside van, remove the hooked
end of the control rod from the control rod clip on
the door (fig. 2-241).
