TM 9-2320-211-20
b. Stowage.
b. Installation (fig. 2-219).
(1) S t r a p t h e c r o s s b a r s a n d p i l l a r p o s t s
(1) Position the windshield assembly to the
together with straps on the rear crossbar.
vehicle, and secure the windshield hinge to the cab
(2) Stow the assembly in (1) above behind the
with eight bolts and nuts.
cab seats.
(2) Connect the wiper hose to the wiper motor
c. Installation (fig, 2-219).
tubing.
(1) Insert the crossbars in bows so that the
2-239. Cab Seat Cushions
crossbar with straps is to the rear bow.
a. Removal.
(2) Position the pillar post assembly into
(1) Remove the cotter pin from the straight
sockets. Tighten the thumb screws on both sides.
p i n securing the link to the frame. Remove the
(3) Raise the cab roof rails and swing them
companion seat cushion.
around into position.
(2) Remove the two cotter pins from the pins
(4) Engage the rail front ends into the upper
securing t h e s e a t b a c k c u s h i o n t o t h e f r a m e .
corner slots of the windshield frame.
Remove the companion seat back cushion from the
2-238. Windshield Assembly
vehicle.
a. Removal (fig. 2-219).
(3) Remove the two nuts and bolts securing
(1) Disconnect the windshield wiper hose at
the operator's seat cushion to the frame. Remove
the lower end of the wiper motor tubing.
the seat cushion.
(2) Remove the eight nuts and bolts securing
(4) Pull the operator's seat back cushion up
the windshield hinges to the cab.
and off the frame.
(3) Remove the windshield assembly from the
vehicle.
