TM 9-2320-366-20-5
20-43. 200 AMP ALTERNATOR KIT INSTALLATION (CONT)
(19) Remove self-locking nut (30), and washer (31) from
voltage regulator terminal (32).
(20) Position terminal lug TL35 (33) on voltage regulator
terminal (32) with washer (31), and self-locking nut (30).
(21) Tighten self-locking nut (30) to 24 lb-in. (3 Nm).
(22) Position dust boot (34) on terminal lug TL35 (33).
(23) Remove screw (35), lockwasher (36), and washer (37)
from alternator (16).
(24) Position ground strap (38) and terminal lug TL5 (39) on
alternator (16) with washer (37), lockwasher (36) and
screw (35).
(25) Tighten screw (35) to 60-84 lb-in. (7-9 Nm).
(26) Position 12 vdc cable (40) and 24 vdc cable (41) in
engine compartment with terminal lugs TL2 (42) and
TL60 (43) located next to alternator (16).
(27) Install dust boot (44) on 12 vdc cable (40).
(28) Install dust boot (45) on 24 vdc cable (41).
(29) Remove terminal lug TL6 (46) from wire (47). Discard
terminal lug.
(30) Position wire (47) in dust boot (45) with terminal lug TL2
(42).
(31) Install terminal lug TL6 (48) on wire (47).
20-230
Change 1
