TM 9-2320-366-20-5
This task covers:
a. Front Pulley Removal
d. Rear Pulley Installation
b. Front Pulley Installation
e. Follow-On Maintenance
c. Rear Pulley Removal
INITIAL SETUP
Equipment Conditions
Tools and Special Tools (Cont)
15K SRW cable extended approximately three feet
Hammer, Hand (Item 17, Appendix C)
(TM 9-2320-366-10-2).
Gloves, Welder's (Item 14, Appendix C)
Cab raised (TM 9-2320-366-10-1).
Goggles, Industrial (Item 15, Appendix C)
Engine shut down (TM 9-2320-366-10-1).
Materials/Parts
Nut, Self-Locking (2) (Item 158, Appendix G)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Nut, Self-Locking (2) (Item 168, Appendix G)
Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C)
WARNING
Cable can become frayed or contain
broken wires. Frayed or broken wires can
injure hands. Wear heavy leather-palmed
work gloves when handling cable. Failure
to comply may result in injury to
personnel.
a. Front Pulley Removal.
(1) Remove 15K SRW cable (1) from front cable pulley (2).
(2) Remove nut (3), washer (4), and cable pulley (2) from
mounting bracket (5).
(3) Remove two screws (6), self-locking nuts (7), and
brackets (8) from mounting bracket (5). Discard self-
locking nuts.
