TM 9-2320-366-20-5
(7) Position roller bracket (5) and taillight bracket (10) on
mounting bracket (11) with two screws (12) and self-
locking nuts (13).
(8) Position two screws (14) in mounting bracket (11) with
two self-locking nuts (15).
(9) Position two screws (16) in taillight bracket (10) with two
self-locking nuts (17).
(10) Tighten two screws (12) to 149-182 lb-ft (202-247 Nm).
(11) Tighten two self-locking nuts (15) to 149-182 lb-ft (202-
247 Nm).
(12) Tighten two screws (16) to 26-32 lb-ft (35-43 Nm).
NOTE
If straight shaft is being replaced, a
replacement spring pin must be installed.
(13) Apply grease to straight shaft (18) and inside of fairlead
roller (19).
NOTE
Install straight shaft so that lubrication fitting
faces toward bottom.
(14) Install fairlead roller (19) and straight shaft (18) in roller
bracket (5).
