TM 9-2320-366-20-4
This task covers:
a. Removal
c. Assembly
b. Disassembly
d. Installation
e. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Materials/Parts (Cont)
Tools removed from tool boxes (TM 9-2320-366-10-
Nut, Self-Locking (20) (Item 164, Appendix G)
1).
Bumper Nonmetallic (4) (Item 4, Appendix G)
Placards removed (para 2-39).
Nut, Self-Locking (14) (Item 135, Appendix G)
M1089 ladder lowered (TM 9-2320-366-10-1).
Lockwasher (20) (Item 111, Appendix G)
Nut, Self-Locking (8) (Item 165, Appendix G)
Lockwasher (8) (Item 112, Appendix G)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Rubber Strip (Item 260, Appendix G)
Wrench, Torque, 0-175 lb-ft (Item 58,
Nut, Self-Locking (14) (Item 133, Appendix G)
Nut, Self-Locking (8) (Item 136, Appendix G)
Sling, Cargo (Item 69, Appendix C)
Nut, Self-Locking (12) (Item 150, Appendix G)
Goggles, Industrial (Item 15, Appendix C)
Nut, Self-Locking (24) (Item 149, Appendix G)
Nut, Self-Locking (2) (Item 176, Appendix G)
Grommet, Nonmetallic (2) (Item 48, Appendix G)
Materials/Parts
Dispenser, Pressure Sensitive Adhesive Tape (Item
Grommet, Nonmetallic (2) (Item 50, Appendix G)
20, Appendix D)
Nut, Self-Locking (Item 147, Appendix G)
Personnel Required
Lockwasher (5) (Item 99, Appendix G)
(2)
a. Removal.
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris. Failure to
comply may result in injury to personnel.
NOTE
Step (1) requires the aid of an assistant.
Front and rear tool boxes are removed the same
way. Rear tool box shown.
(1) Remove self-locking nut (1), two washers (2), and screw
(3) from ladder support hand rail bracket (4). Discard
self-locking nut.
