TM 9-2320-366-20-4
16-11. FENDER AND SPLASH GUARD REPLACEMENT (CONT)
s. M1089 Rear Splash Guard Removal.
NOTE
Left and right rear splash guards are
removed the same way. Right side shown.
(1) Remove two pinlocks (1) and rear splash guard (2) from
sandshoe (3).
(2) Remove five self-locking nuts (4), ten washers (5), five
screws (6), and two plates (7) from rear splash guard
(2). Discard self-locking nuts.
t. M1089 Rear Splash Guard Installation.
NOTE
Left and right rear splash guards are installed
the same way. Right side shown.
(1) Position two plates (1) on rear splash guard (2) with five
screws (3), ten washers (4), and five self-locking nuts
(5).
(2) Tighten five self-locking nuts (5) to 18-22 lb-ft (24-30
Nm).
(3) Install rear splash guard (2) on sandshoe (6) with two
pinlocks (7).
16-102
