TM 9-2320-366-20-4
(3) Remove self-locking nut (9), washer (10), and screw (11)
from bracket (7). Discard self-locking nut.
(4) Remove bracket (7) from mounting bracket (12).
(5) Remove two self-locking nuts (13), screws (14), and
mounting bracket (12) from bumper (15). Discard self-
locking nuts.
p. M1088 Rear Splash Guard and Mounting Bracket
Installation.
NOTE
Left and right rear splash guards and
mounting brackets are installed the same
way. Left side shown.
(1) Position mounting bracket (1) on bumper (2) with two
screws (3) and self-locking nuts (4).
(2) Tighten two self-locking nuts (4) to 149-183 lb-ft (202-
248 Nm).
16-99
