TM 9-2320-366-20-4
Section II. MAINTENANCE PROCEDURES
ADJUSTMENT
This task covers:
a. Removal
c. Latch Adjustment
b. Installation
INITIAL SETUP
Equipment Conditions
Tools and Special Tools (Cont)
Engine shut down (TM 9-2320-366-10-1).
Drill Set, Twist (Item 6, Appendix C)
Tool Kit, Blind Rivet (Item 44, Appendix C)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Material/Parts
Drill, Portable, Electric (Item 7, Appendix C)
Rivet, Blind (4) (Item 248, Appendix G)
Goggles, Industrial (Item 15, Appendix C)
a. Removal.
(1) Pull two spring catches (1) and lift two latch levers (2).
(2) Release two latch hooks (3) from two strike plates (4).
(3) Remove PDP cover (5) from dashboard (6).
WARNING
Wear appropriate eye protection when
removing rivets. Failure to comply may result
in injury to personnel.
(4) Remove four rivets (7) and two strike plates (4) from
PDP cover (5).
Change 1
