TM 9-2320-366-20-4
This task covers:
a. Removal
d. Installation
b. Disassembly
e. Follow-On Maintenance
c. Assembly
INITIAL SETUP
Equipment Conditions
Tools and Special Tools (Cont)
Engine shut down (TM 9-2320-366-10-1).
Separator, Ball Joint (Item 44, Appendix B)
Cab raised (TM 9-2320-366-10-1).
Wrench Set, Socket (Item 50, Appendix C)
Steering wheel turned fully left (TM 9-2320-366-
Goggles, Industrial (Item 15, Appendix C)
10-1).
Materials/Parts
Pin, Cotter (2) (Item 228, Appendix G)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Wrench, Torque, 0-600 lb-ft (Item 60, Appendix
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris. Failure to
comply may result in injury to personnel.
a. Removal.
(1) Remove cotter pin (1) from drag link (2). Discard cotter
pin.
(2) Remove slotted nut (3) from drag link (2).
(3) Remove drag link (2) from pitman arm (4).
Change 1
