TM 9-2320-366-20-4
This task covers:
a. Removal
d. Installation
b. Disassembly
e. Follow-On Maintenance
c. Assembly
INITIAL SETUP
Equipment Conditions
Tools and Special Tools (Cont)
Engine shut down (TM 9-2320-366-10-1).
Socket, Socket Wrench (Item 38, Appendix C)
Cab raised (TM 9-2320-366-10-1).
Wrench Set, Socket (Item 50, Appendix C)
Goggles, Industrial (Item 15, Appendix C)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Materials/Parts
Wrench, Torque, 0-600 lb-ft (Item 90,
Pin, Cotter (2) (Item 223, Appendix G)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris. Failure to
comply may result in injury to personnel.
a. Removal.
NOTE
Left and right tie rod ends are removed the
same way. Left side shown.
(1) Remove cotter pin (1) and slotted nut (2) from each end
of tie rod (3). Discard cotter pins.
(2) Remove tie rod (3) from two steering knuckle arms (4).
Change 1
