TM 9-2320-366-20-4
NOTE
Perform step (3) on transmissions SN
6510069120 and higher.
(3) Position gasket (4) and transmission oil filter cover (2)
on transmission control module (5) with six screws (6).
NOTE
Perform step (4) on transmissions SN lower
than 6510069120
(4) Position transmission oil filter cover (2) on trans-mission
control module (5) with six screws (6).
(5) Tighten six screws (6) to 38-45 lb-ft (52-61 Nm) in
sequence shown.
CAUTION
Ensure needle bearings are aligned prior to
installation of bearing cups on universal joint
trunnions. Failure to comply may result in
damage to equipment.
(6) Position universal joint (7) in drive yoke (8) with two
bearing cups (9) and four screws (10).
NOTE
When correct torque is reached, bearing cap
screw small hex head will break off.
(7) Tighten four screws (10) to 26-35 lb-ft (35-47 Nm).
NOTE
Perform step (7.1) on bearing cups equipped
with tabs.
(7.1) Fold down tabs on bearing cups (9).
(7.2) Tighten four screws (10) to 26-35 lb-ft (35-47 Nm).
Change 2
8-37
