TM 9-2320-366-20-4
CAUTION
Use care when removing retaining plates
from universal joint. Failure to comply may
result in damage to equipment.
NOTE
Perform step (9) on bearing cups equipped
with tabs.
(9) Lift tabs from two bearing cups (8).
(9.1) Remove four screws (7) and two bearing cups (8)
from drive yoke (9). Discard screws.
(10) Slide drive shaft (10) from side to side and
separate universal joint (10.1) from drive yoke (9).
NOTE
Both transmission oil filters are removed the
same way. Right side transmission oil filter
shown.
(11)
Remove six screws (11) from transmission oil filter
cover (12).
NOTE
Perform step (12) on transmissions SN
lower than 6510069120.
(12)
Remove transmission oil filter cover (12) and trans-
mission oil filter (13) from transmission control valve
module (1).
NOTE
Perform step (13) on transmissions SN
6510069120 and higher.
(13)
Remove transmission oil filter cover (12), gasket
(14), and transmission oil filter (13) from
transmission control valve module (1). Discard
gasket.
(14) Remove transmission oil filter (13) from transmission
oil filter cover (12).
Change 2
8-35
