TM 9-2320-272-24-4
2.
Remove two screws (2) and adjusting nut locks (3) from bearing caps (6).
CAUTION
Scribe bearing caps and saddles for installation. These items are
machine-matched and damage will result if they are intermixed.
3.
Remove four screws (4), washers (5), and two bearing caps (6) from differential carrier housing (11).
NOTE
Tag bearings and races as matched parts for inspection and
installation.
4.
Remove two adjusting nuts (9) and bearing races (8) from bearing saddles (10) and caps (6).
5.
Remove differential gear assembly (7) from differential carrier housing (11) and bearing
saddles (10).
6.
Using puller, remove two tapered roller bearings (12) from differential housings (13).
7.
Remove safety wire (18) from eight slotted nuts (19). Discard safety wire (18).
CAUTION
Two gear housings and helical drive gear must be scribed for
installation. These items are machine-matched and damage may
result if they are intermixed.
8.
Remove eight slotted nuts (19) and screws (22) from two differential housings (13). Mark two
differential housings (13) and helical ring gear (16) for installation.
9.
Remove four bevel spider gears (20), thrust washers (21), and spider (17) from differential
housing (13).
10.
Remove two bevel side gears (15) and thrust washers (14) from differential housings (13).
5-433
