TM 9-2320-272-24-4
Section V. FRONT AND REAR AXLE MAINTENANCE
THIS TASK COVERS:
a.
Disassembly
c. Assembly and Adjustment
b.
Cleaning, Inspection, and Repair
INITIAL SETUP:
APPLICABLE MODELS
MATERIALS/PARTS
All
Gasket (Appendix D, Item 206)
Gasket (Appendix D, Item 207)
SPECIAL TOOLS
Gasket (Appendix D, Item 208)
Three safety wires, 12 in. (Appendix D, Item 568)
Bearing replacer (Appendix E, Item 14)
Wear sleeve kit (Appendix D, Item 717)
Two puller screws (Appendix E, Item 104)
Gasket and shim set (Appendix D, Item 248)
TOOLS
Six lockwashers (Appendix D, Item 350)
Locktab washer (Appendix D, Item 344)
General mechanic's tool kit
Two cotter pins (Appendix D, Item 61)
(Appendix E, Item 1)
Two oil seals (Appendix D, Item 500)
Mechanical puller kit (Appendix E, Item 102)
Gasket (Appendix D, Item 653)
Inside micrometer
Six lockwashers (Appendix D, Item 354)
Safety wire, 36 in. (Appendix D, Item 568)
Torque wrench (Appendix E, Item 146)
Crocus cloth (Appendix C, Item 20)
Torque wrench (Appendix E, Item 145)
GAA grease (Appendix C, Item 28)
Dial indicator (Appendix E, Item 36)
Lubricating oil (Appendix C, Item 47)
Outside micrometer (Appendix E, Item 80)
Blue oil-base pigment (Appendix C, Item 54)
Arbor press
Sealing compound (Appendix C, Item 61)
Torque multiplier
Sealing compound (Appendix C, Item 62)
Vise
Twine (Appendix C, Item 77)
Soft-head hammer
White carbonate pigment (Appendix C, Item 78)
Chain
Lifting device
REFERENCES (TM)
Bearing preload tester
LO 9-2320-272-12
TM 9-214
TM 9-2320-272-24P
EQUIPMENT CONDITION
Differential and carrier assembly removed
(para. 4-100).
NOTE
Front and rear differentials are repaired the same way.
1.
Remove safety wires (1) from two screws (2) and four screws (4). Discard safety wires (1).
5-432
