TM 9-2320-272-24-4
29.
Remove eight screws (9) and washers (10) from side cover (11).
30.
Remove side cover (11) and gasket (12) from differential carrier housing (13). Discard gasket (12).
31.
Remove six screws (17) and lockwashers (16) from bearing retaining plate (15). Discard
lockwashers (16).
NOTE
Record number and thickness of shims for installation.
32.
Remove bearing retaining plate (15) and shims (14) from differential carrier housing (13). Discard
shims (14).
33.
Remove safety wire (22) from three screws (23) on retaining plate (21). Discard safety wire (22).
34.
Remove three screws (23) and retaining plate (21) from shaft (18).
35.
Install two puller screws (24) in tapped jacking holes (25) in bearing cap (20) and remove bearing
cap (20). Tighten screws (24) evenly while removing bearing cap (20). Remove puller
screws (24) from bearing cap (20).
NOTE
Tag and retain shims for measurement and installation.
Remove shims (19) from differential carrier housing (13).
36.
37.
Using arbor press, remove two bearings (27) and races (26) from bearing cap (20).
5-437
