TM 9-2320-260-34-2
16-48. POWER DIVIDER REPAIR (Contd)
18. Remove two screws (23), lockwashers (24), cover plate (25), and gasket (26) from adapter (27).
19. Remove four screws (44), lock washers (43), adapter (27), and gasket (42) from housing (10). Discard
lockwashers (43) and gasket (42).
20. Remove seal (28) from adapter (27). Discard seal (28).
NOTE
Clutch gear will catch bearing as shaft passes through clutch gear.
21.
Using a brass drift and hammer, tap adapter end (33) of pump shaft (21) to force pump shaft (21)
through positive clutch gear (30), bore (29), and spur gear (39).
22.
Remove pump shaft rear bearing (32) from pump shaft (21).
23.
Remove pin (31) from pump shaft (21). Discard pin (31).
24.
Remove pump shaft front bearing (41), thrust washer (40), spur gear (39), and clutch thrust
washer (35) through opening (34) of housing (10).
25.
Remove roller bearings (36) and (38) and spacer (37) from spur gear (39).
16-281