TM 9-2320-260-34-2
16-48. POWER DIVIDER REPAIR (Contd)
26.
Remove screw (22), Iockwasher (21), washer (20), and gasket (19) from input shaft (6). Discard
lockwasher (21) and gasket (19).
27.
Using puller, remove yoke (23) from input shaft (6).
28.
Remove four screws (18), lockwashere (17), cap (24), and gasket (15) from housing (13). Discard
lockwashers (17) and gasket (15).
29.
Remove seal (16) from cap (24). Discard seal (16).
30.
Remove four screws (9), lockwashers (10), cover (11), and gasket (12) from housing (13). Discard
lockwashers (10) and gasket (12).
Place housing (13) on blocking with splined end of input shaft (6) down. Blocking must be high
31.
enough to allow clearance for input shaft (6).
32.
Using brass drift and hammer, tap input shaft (6) and outer race of input shaft bearing (1) to force
shaft. (6) and input shaft bearing (1) back through bore (14) of housing (13).
33.
Remove input shaft bearing (1) and input shaft (6) through bore (14) of housing (13).
34.
Remove input shaft bearing (8), input gear thrust washer (5), clutch (7), drive gear (4), and input
gear thrust washer (2) from housing (13).
35.
Remove roller bearing (3) from drive gear (4).
Press input gear bearing (1) from input shaft (6).
36.
16-282
