TM 9-2320-260-34-2
16-5. FRONT WINCH ROLLER MAINTENANCE (Contd)
d. Assembly
NOTE
Right and left side rollers and brackets are assembled the same.
This procedure covers the right side roller and bracket.
1.
Position two thrust washers (9) and side roller (10) in right roller bracket (4) and install with pin (8).
Ensure drive pin (11) hole alines in both pin (8) and right roller bracket (4).
2.
Install drive pin (11) in right roller bracket (4) and pin (8).
Install grease fitting (7) on top end of pin (8).
3.
NOTE
Perform steps 4 and 5 for front winch model 7412382.
4.
Install rub bar (12) on bracket (3) with three screws (13).
Install bracket (3) on right roller bracket (4) with two screws (6), washers (5), new lockwashers (2),
5.
and nuts (1).
Install bearings (15) in each end of roller (16).
6.
7.
Soak two new felt washers (14) in lubricating oil and install in roller (16).
Install roller shaft (18) in right roller bracket (4) and aline setscrew holes in roller shaft (18) and
8.
right roller bracket (4).
9.
Secure roller shaft (18) in right roller bracket (4) with two setscrews ( 19).
10.
Install thrust washer (17) and roller (16) on roller shaft (18).
11.
Position thrust washer (22) and left roller bracket (21) on roller shaft (18).
12.
Install two grease fittings (20) in ends of roller shaft (18).
16-38