TM 9-2320-260-34-1
7-4. REAR WIRING HARNESS REPLACEMENT (Contd)
NOTE
Step 36 applies to M820 vehicles.
36. Disconnect connector (5) from clearance light wire (6).
CAUTION
Use care when removing rear wiring harness from vehicle. Pulling
and snagging may cause damage to harness.
NOTE
Tag all clamps for installation.
Refer to table 7-2, Rear Wiring Harness Clip Quantity, for
number of clips used.
Assistant will help with step 37.
37.
Bend clips (8) open and remove rear wiring harness (3) from rear crossmember (7), left side frame
rail (4), under cab floor (1), and front receptacle (2).
VEHICLE
NUMBER OF CLIPS
12
M813, M813A1, M815
14
M814
15
M816
6
M817
7
M818
10
M819
9
M820
Use care when routing rear wiring harness into vehicle. Pulling
and snagging may cause damage to harness.
NOTE
If new rear wiring harness is to be installed, remove all tags
from old harness and install on new harness.
Assistant will help with step 1.
1.
Position rear wiring harness (3) in approximate location on rear crossmember (7), left side frame
rail (4), under cab floor (1), and front receptacle (2).
7-30