TM 9-2320-260-34-1
7-4. REAR WIRING HARNESS REPLACEMENT (Contd)
NOTE
Steps 24 through 35 apply to M819 vehicles.
24.
Remove locknut (24), two wires (25), lockwasher (23), and screw (22) from left frame rail (21).
Discard locknut (24) and lockwasher (23).
25.
Remove locknut (26), clamp (2), and screw (4) from clip extension (3). Discard locknut (26).
26.
Remove clamp (2) from rear wiring harness (1).
27.
Remove two locknuts (5), screws (8), and clamps (7) and (9) from subframe (6). Discard locknuts (5).
28.
Remove clamps (7) and (9) from rear wiring harness (1).
29.
Remove two locknuts (11), screws (19), four washers (12), and clamps (10) and (13) from rear left
fender (20). Discard locknuts (11).
30.
Remove clamps (10) and (13) from rear wiring harness (1).
NOTE
Receptacle cover must be lifted and held open to remove top two
screws.
Remove four locknuts (18), screws (16), cover (15), and harness receptacle (17) from body (14).
31.
Discard locknuts (18).
Remove locknut (40), two wires (27), lockwasher (28), and screw (29) from rear crossmember (39).
32.
Discard locknut (40) and lockwasher (28).
Remove locknut (30), clamp (33), and screw (32) from bracket (31). Discard locknut (30).
33.
Remove clamp (33) from rear wiring harness (1).
34.
NOTE
Receptacle cover must be lifted and held open to remove top two
screws.
Remove four locknuts (38), screws (36), cover (35), and trailer receptacle (37) from bracket (34).
35.
Discard locknuts (38).
7-28