TM 9-2320-260-34-1
3-17. FUEL CROSSOVER CONNECTOR REPLACEMENT
THIS TASK COVERS:
b. Installation
a. Removal
INITIAL SETUP
REFERENCES (TM)
APPLICA8LE MODELS
TM 9-2320-260-10
All
TM 9-2320 -260-34P-1
TOOLS
EQUIPMENT CONDITION
General mechanic's tool kit
Parking brake set (TM 9-2320-260-10).
(Appendix B, Item 1)
Rocker lever housing and push tubes removed
Torque wrench, 318-in. dr.
(Appendix B, Item 4)
Socket driver, 318-in. dr.
GENERAL SAFETY INSTRUCTIONS
(Appendix B, Item 144)
Diesel fuel is flammable. Do not perform this task
MATERIALS/PARTS
near open flame.
Four screw-assembled lockwashers
(Appendix D, Item 383)
Four O-rings (Appendix D, Item 270)
WARNING
Diesel fuel is flammable. Do not perform fuel system procedures
near open flame. Injury to personnel may result.
NOTE
All fuel crossover connectors are replaced the same way. This
procedure covers one fuel crossover connector.
a.
Removal
Remove four screw-assembled lockwashers (1), fuel crossover connector (2), and four O-rings (4) from
cylinder heads (3). Discard O-rings (4) and screw-assembled lockwashers (1).
b.
Installation
Install four new O-rings (4) and fuel crossover connector (2) on cylinder heads (3) with four new screw-
assembled lockwashers (1). Tighten screw-assembled lockwashers (1) 34-38 lb-in. (3.8-4.3 Nm).
FOLLOW-ON TASK: Install rocker lever housing and push tubes (para. 3-15).
