TM 9-2320-260-34-1
3-15. ROCKER LEVER HOUSING AND PUSH TUBES MAINTENANCE (Contd)
NOTE
Apply lubricating oil to all parts before installation.
1.
Install six adjusting screws (2) and nuts (1) on two exhaust (3), injector (4), and intake (5) rocker
levers.
CAUTION
Ensure rocker lever shaft oil holes are properly alined with oil
passages in rocker lever housing. Failure to do so may cause
lubrication failure and engine damage.
2.
Position two exhaust (3), injector (4), and intake (5) rocker levers in rocker lever housing (10).
3.
Install rocker lever shaft (7) through rocker lever housing (10) and rocker levers (3), (4), and (5).
Ensure mark on plugs (9) face upward.
4.
Push rocker lever shaft (7) until it extends from rocker lever housing ( 10) and install new
packing (11) on rocker lever shaft (7) from outside rocker lever housing (10).
5.
Push rocker lever shaft (7) until it extends from opposite end of rocker lever housing (10) and install
new packing (8) on rocker lever shaft (7) from outside rocker lever housing (10).
Aline hole in rocker lever shaft (7) with hole in rocker lever housing (10).
6.
7.
Apply sealant to threads of setscrew (6) and install in rocker lever housing (10).
3-44