TM 9-2320-260-34-1
3-15. ROCKER LEVER HOUSING AND PUSH TUBES MAINTENANCE (Contd)
NOTE
Perform steps 1 through 5 if inspection requires replacement of
defective parts.
1. Using arbor press, remove bushing (12) from rocker lever (13). Discard bushing (12).
CAUTION
Ensure new bushing oil holes are properly alined to oil passages in
rocker levers. Failure to do so will cause lubrication failure and
severe engine damage.
NOTE
so that oil holes to crosshead nose or injector link and adjusting
screw are open.
Ensure bushing is installed in intake rocker levers so that oil
hole at crosshead nose is closed and slot is aligned with oil hole
at adjusting screw end.
2. Using arbor press install bushing (12) from rocker lever (13).
3. Drill a small hole in injector lever (15) above socket seat (16).
4. Push socket seat (16) from injector lever (15). Discard socket seat (16).
5. Stake plug (14) in hole and install new socket seat (16) in injector lever (15).
3-43
