TM 9-2320-260-34-1
THIS TASK COVERS:
a. Removal
d. Repair
e. Assembly
b. Disassembly
f. Installation
c. Cleaning and Inspection
INITIAL SETUP
REFERENCES (TM)
APPLICABLE MODELS
TM 9-2320-260-10
All
TM 9-2320-260-34P-1
TOOLS
EQUIPMENT CONDITION
General mechanic's tool kit
Parking brake set (TM 9-2320-260-10).
(Appendix B, Item 1)
Fuel pump removed (for cylinder 3 and 4)
(Appendix B, Item 4)
Arbor press (Appendix B, Item 7)
Rocker lever housing and push tubes removed
Nano reamer set (Appendix B, Item 112)
Soft-head hammer (Appendix B, Item 47)
GENERAL SAFETY INSTRUCTIONS
Drill press (Appendix B, Item 53)
Keep fire extinguisher nearby when using
Countersink tool set (Appendix B, Item 138)
drycleaning solvent.
MATERIALS/PARTS
Compressed air source will not exceed 30 psi
Gasket (Appendix D, Item 155)
(207 kPa).
Eyeshields must be worn when cleaning with
compressed air.
(Appendix D, Item 391)
Two plugs (Appendix D, Item 322)
Lubricating oil (Appendix C, Item 21)
Drycleaning solvent (Appendix C, Item 48)
Bar soap (Appendix C, Item 46)
Blue pigment (Appendix C, Item 26)
Screw (Appendix C, Item 35)
a.
Removal
CAUTION
Do not discard cam follower housing gasket before measuring total
thickness of each gasket. Total thickness of all gaskets is critical
for seating of cam followers on camshaft for correct injector and
valve timing. Damage to engine will result if gasket spacing is
not correct when installing cam followers.
NOTE
All cam follower housings are removed basically the same way.
This procedure is for number 5-6 cam follower housing.
Tag cam follower housing(s) for installation.