TM 9-2320-211-20
(8) Remove the cotter pin, slotted nut, lock-
pump drive shaft. Pull the fan pulley from the
c. I n s t a l l a t i o n (fig. 2-130).
shaft.
(1) Position the belts over the fan, crankshaft,
(2) Adjust the belts as described in a above.
a. Removal.
(1) Drain the cooling system. Refer to TM 9-
2320-21-10.
left and right frame brackets and at the left a n d
right brush guard braces, and tilt the upper end of
the brush guard forward.
(3) Remove the radiator upper shield (para 2-
(4) Remove the radiator stay rod from the
b. Installation.
( 5 ) Loosen the front hose c l a m p o n t h e
water pump drive shaft, and secure the pulley with
end of the radiator forward.
the washer, lockwasher, slotted nut, and cotter pin.
the fan pulley hub, and install six capscrews and
and remove the fan.
(3) Push the upper end of the radiator toward
the rear of the vehicle, and install the radiator stay
(4) Slide the front end of the radiator inlet
the hose clamp.
(5) Install the radiator upper shield (para 2-
(6)
Push the top of the brush guard toward
the rear of the vehicle, and engage the slots in the
the brush guard. Tighten the guard-to-frame
bracket nuts and bolts and the guard-to-brace nuts
and bolts.
(7) Fill the cooling system. Refer to TM 9-
2320-211-10.