TM 9-2320-366-20-5
19-4. HYDRAULIC MANIFOLD REPLACEMENT/REPAIR (CONT)
(37) Position spacer (61) on hydraulic manifold (2) with three
screws (62).
(38) Tighten two screws (62) to 72-120 lb-in. (8-14 Nm).
(39) Position hinge (63) on spacer (61) with two screws (62).
(40) Tighten two screws (64) to 18-22 lb-ft (24-30 Nm).
(41) Position spacer (65) and cover (66) on hinge (63) with
two screws (67) and self-locking nuts (68).
(42) Tighten two self-locking nuts (68) to 18-22 lb-ft (24-30
Nm).
(43) Position plate (69) and lanyard (70) on hydraulic
manifold (2) with two screws (71).
(44) Tighten two screws (71) to 18-22 lb-ft (24-30 Nm).
(45) Close cover (66) and install retaining pin (72).
f. Installation.
(1) Connect eight hydraulic hoses (1) to fittings (2).
(2) Connect two hydraulic hoses (3) to 45-degree fittings (4).
(3) Connect four air hoses (5) to air fittings (6).
Change 1
