TM 9-2320-366-20-5
This task covers:
a. Removal
c. Follow-On Maintenance
b. Installation
INITIAL SETUP
Equipment Conditions
Tools and Special Tools (Cont)
Crossbar assembly removed (para 16-69).
Wrench Set, Crowfoot, Ratcheting (TM 9-2320-366-20)
Stinger extended with outer end slightly higher
than inner end (TM 9-2320-366-10-2).
Materials/Parts
Engine shut down (TM 9-2320-366-10-1).
Dispenser, Pressure Sensitive Adhesive Tape (Item 30,
Hydraulic reservoir supply and return valve
closed (TM 9-2320-366-10-2).
Solvent, Dry Cleaning (Item 83, Appendix C)
Preformed Packing (2) (Item 234, Appendix F)
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Personnel Required
Goggles, Industrial (Item 28, Appendix B)
(2)
Pan, Drain (Item 43, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 92, Appendix
a. Removal.
WARNING
Use care when removing retaining rings.
Retaining rings are under tension and
can act as projectiles when released.
Failure to comply may result in injury to
personnel.
(1) Remove two retaining rings (1) from retaining pin
(2).
(2) Remove retaining pin (2) from inner tube (3).
17-151
