TM 9-2320-366-20-4
16-17. TOOL BOX REPLACEMENT/REPAIR (CONT)
c. Assembly.
(1) Cut two seals (1) to 8.75 in. (22.2 cm) long.
(2) Cut two seals (2) to 11.15 in. (28.3 cm) long.
(3) Install two seals (1) and seals (2) on tool box door (3)
0.12-0.20 in. (0.3-0.5 cm) offset from edge of tool box
door.
(4) Install bail (4) and stop washer (5) on shaft (6).
(5) Install plate (7) and shaft (6) on tool box door (3) with
spring washer (8), key washer (9), and nut (10).
(6) Bend up two tabs on key washer (9)
(7) Install latch pawl (11) on shaft (6).
NOTE
Tool boxes disassembled with rivets attaching
tool box door, will require tool box door and
tool box mounting holes be enlarged to 0.250
in. (0.625 cm).
(7.1) Drill out 5 holes in tool box (13) and tool box door (3).
(8) Install hinge (12) on tool box (13) with five screws (13.1)
and nuts (13.2).
(9) Install tool box door (3) on hinge (12) with five screws
(14) and nuts (15).
Change 1
