TM 9-2320-366-20-4
16-12. CAB STEP REPLACEMENT (CONT)
(3) Install turnlock receptacle (6) on cab step (7).
(4) Cut two seals (8) to 7.25 in. (18.4 cm) long.
(5) Cut one seal (9) to 16.3 in. (41.4 cm) long.
(6) Install seal (9) on cab step tread (2) as shown.
(7) Install two seals (8) on cab step tread (2) as shown.
(8) Position cab step tread (2) on cab step (7) with two
washers (10), screws (11), and self-locking nuts (12).
(9) Tighten two self-locking nuts (12) to 21-27 lb-ft (28-37
Nm).
(10) Position cab step (7) on fender (13) with four screws
(14), eight washers (15), and four self-locking nuts (16).
(11) Position four screws (17), eight washers (18), and four
self-locking nuts (19) in cab step (7).
(12) Tighten four self-locking nuts (16 and 19) to 21-27 lb-ft
(28-37 Nm).
(13) Close cab step tread (2) on cab step (7).
c. Follow-On Maintenance.
(1) Lower cab (TM 9-2320-366-10-1).
(2) Install windshield washer reservoir and pump (for left
side) (para 18-2).
End of Task.
16-120
