TM 9-2320-366-20-4
This task covers:
a. Removal
d. Installation
b. Disassembly
e. Follow-On Maintenance
c. Assembly
INITIAL SETUP
Equipment Conditions
Materials/Parts
Engine shut down (TM 9-2320-366-10-1).
Washer, Spring (8) (Item 296, Appendix G)
Air tanks drained (TM 9-2320-366-10-1).
Dispenser, Pressure Sensitive Adhesive Tape
Worklight assembly removed (para 7-42).
(Item 20, Appendix D)
M1088 mounting bracket removed (para 14-6).
Antiseize Compound (Item 58, Appendix D)
Nut, Self-Locking (2) (Item 156, Appendix G)
Nut, Self-Locking (2) (Item 169, Appendix G)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Nut, Self-Locking (2) (Item 154, Appendix G)
Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C)
Nut, Self-Locking (3) (Item 155, Appendix G)
Wrench, Torque, 0-75 lb-in. (Item 90, Appendix B)
Lockwasher (Item 89, Appendix G)
Goggles, Industrial (Item 15, Appendix C)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when working under vehicle due to the possibility of falling
debris. Failure to comply may result in injury to personnel.
a. Removal
NOTE
Vehicle serial numbers 0001 through 2359 were
not originally equipped with gladhand selector
valves. Vehicle serial numbers 2360 and higher
are equipped with gladhand selector valves.
M1088 with gladhand selector valves shown.
Tag hoses and connection points prior to
disconnecting.
(1) Disconnect two air hoses (1) from 45-degree fittings (2).
NOTE
Perform steps (2) and (3) on vehicles
equipped with gladhand selector valves.
(2) Disconnect hose (3) from 90-degree fitting (4).
(3) Disconnect hose (5) from 90-degree fitting (6).
Change 1
