TM 9-2320-366-20-4
This task covers:
a.
Removal
c.
Follow-On Maintenance
b.
Installation
INITIAL SETUP
Equipment Conditions
Tools and Special Tools (Cont)
Engine shut down (TM 9-2320-366-10-1).
Wrench, Torque, 0-200 lb-in. (Item 59,
Turn signal switch removed (para 7-26).
Cab raised (TM 9-2320-366-10-1).
Wrench Set, Socket (Item 49, Appendix C)
Gloves, Rubber (Item 13, Appendix C)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Materials/Parts
Goggles, Industrial (Item 15, Appendix C)
Sealing Compound (Item 55.2, Appendix D)
Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C)
Washer, Spring (2) (Item 292, Appendix G)
Locknut (Item 68, Appendix G)
Nut, Self-Locking (4) (Item 128, Appendix G)
a. Removal.
(1) Remove four self-locking nuts (1), eight washers (2),
and four screws (3) from steering column assembly
(4). Discard self-locking nuts.
(2) Remove locknut (5) and bolt (6) from steering gear
arm universal joint (7). Discard locknut.
(3) Disconnect steering gear arm universal joint (7) from
steering gear input shaft (8).
(4) Lower cab (TM 9-2320-366-10-1).
Change 2
