TM 9-2320-366-20-4
This task covers:
a. Removal
c. Follow-On Maintenance
b. Installation
INITIAL SETUP
Equipment Conditions
Tools and Special Tools (Cont)
Tire removed (TM 9-2320-366-10-2).
Respirator, Air Filter (Item 29, Appendix C)
Rear spring brakes caged (para 11-6).
Personnel Required
(2)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
a. Removal.
WARNING
Spring brakes must be caged before attempting replacement of a rear axle wheel stud. Failure to
comply may result in severe injury to personnel.
Wheel drum weighs approximately 92 lbs (42 kgs). Use the aid of an assistant to help remove
wheel drum from axle. Failure to comply may result in injury to personnel.
Brake shoes may be covered with dust. Breathing this dust may be harmful to your health. Do not use
compressed air to clean brake shoes. Wear a filter mask approved for use against brake dust. Failure
to comply may result in injury to personnel.
CAUTION
Wheel studs and nuts on left side of vehicle
have left hand threads. Nuts must be turned
to the right to loosen. Wheel studs and nuts
on right side of vehicles have right hand
threads. Nuts must be turned to the left to
loosen. Failure to comply may result in
damage to equipment.
NOTE
Step (1) requires the aid of an assistant.
(1) Remove wheel drum (1) from wheel hub (2).
(2) Turn hub to position stud (3), to be replaced, at top or
bottom position.
(3) Knock stud (3) out through back side of wheel hub (2).
