TM 9-2320-366-20-4
(37) Connect six air hoses (18) to tee fittings (14, 15, and
17).
(38) Start engine (TM 9-2320-366-10-1) and allow time for
REAR BRAKE AIR pressure gage to reach at least 100
psi.
(39) Push in SYSTEM PARK control (TM 9-2320-366-10-1).
(40) Loosen two nuts (19) on caging bolts (20).
(41) Remove two caging bolts (20) from front and rear air
chambers (2 and 11).
NOTE
Steps (42) through (44) require the aid of an
assistant.
(42) Apply brake pedal and continue holding until steps (43)
and (44) are accomplished.
(43) Hand tighten collet nuts (1 and 10) against plunger
housings (3 and 12).
(44) Tighten collet nuts (1 and 10) 3/16 turn (1/2 teeth).
Change 1
