TM 9-2320-366-20-4
c. Installation.
(1) Turn two adjusting screws (1) in plunger housing (2) until
they bottom.
(2) Apply a film of grease to slots (3) in two adjusting screws
(1), anchor plungers (4) and to inside of two holddown
clips (5).
CAUTION
Do not rely on automatic adjusters to take up
excessive initial clearance. Tightening adjusting
screws against plunger housings may result in
failure of automatic adjusters to function
properly. Failure to comply may result in
damage to equipment.
Brake shoe ends stamped ADJUSTER are
positioned on adjusting screws. Failure to
comply may result in damage to equipment.
(3) Loosen two adjusting screws (1) 1/2 turn or until slots (3)
are aligned with brake shoes (6).
(4) Install two brake shoes (6) in holddown clips (5) with
ends seated in slots in adjusting screws (1) and anchor
plungers (4).
(5) Install two return springs (7) on brake shoes (6).
11-5
