TM 9-2320-66-20-4
WARNING
Adhesives, solvents, and sealing com-
pounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. Keep away from open fire
and use in a well-ventilated area. If
adhesive, solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and water. Failure
to comply may result in injury to
personnel.
(8) Apply a small bead of gasket maker to mating
surface of bevel gear hub cover (15).
(9) Install bevel gear hub cover (15) on wheel end hub
assembly (9).
(10) Position 12 screws (16) in bevel gear hub cover
(15).
(11) Tighten 12 screws (16) to 35-50 lb-ft (47-68 Nm).
d.
Follow-On Maintenance.
(1) Fill hub assembly (front axle) (Appendix H).
(1.1) Refill axle differential (intermediate and rear axle)
(2) Start engine (TM 9-2320-366-10-1).
(3) Test operate vehicle and check for unusual noise
or vibration from planetary drive assembly.
(4) Shut down engine (TM 9-2320-366-10-1).
(5) Check for oil leaks around bevel gear hub cover.
End of Task.
Change 2
