TM 9-2320-366-20-4
CAUTION
Install bevel washers with tapered end toward
transmission auxiliary oil cooler. Failure to
comply may result in damage to equipment.
(6) Position two brackets (9) and six bevel washers (10) on
transmission auxiliary oil cooler (3) with four washers
(11), screws (12), washers (13), lockwashers (14), and
nuts (15).
(7) Tighten four nuts (15) to 20-30 lb-ft (27-41 Nm).
NOTE
Steps (8) through (15) requires the aid of an
assistant.
(8) Position transmission auxiliary oil cooler (3) on vehicle.
NOTE
Right front and rear brackets are installed the
same way. Right front bracket shown.
(9) Position two spacers (16), spacers (17), and bracket (18)
on bracket (9) with screw (19) and self-locking nut (20).
(10) Position screw (21) and self-locking nut (22) in bracket
(18).
(11) Tighten self-locking nuts (20 and 22) to 20-30 lb-ft (27-41
Nm).
(12) Perform steps (8) through (11) on right rear bracket.
Change 1
8-48.1/(8-48.2 Blank)
