TM 9-2320-366-20-4
NOTE
Reference points are from inside passenger
side dashboard.
(11) Measure and mark a line 2.0 in. (5 cm) from point A to
point B in dashboard (10).
NOTE
Position WTEC III transmission ECU in
dashboard with mounting tabs down.
(12) Position WTEC III transmission ECU (11) in dashboard
(10) with single mounting tab over matchmark.
CAUTION
Do not position WTEC III transmission ECU on
weldnuts in dashboard. Failure to comply may
result in damage to equipment.
(13) Match mark mounting tabs on WTEC III transmission
ECU (11) with centerpunch.
(14) Remove WTEC III transmission ECU (11) from
dashboard (10).
WARNING
Wear goggles when drilling metal. Failure
to comply may result in injury to
personnel.
(15) Drill a pilot hole at centerpunch points marked in step
(13).
(16) Enlarge three pilot holes in step (15) to 0.315 in. (0.8
cm).
(17) Install WTEC III transmission ECU (11) under dashboard
(10) with three washers (16), screws (17), washers (18),
and nuts (19).
8-29