TM 9-2320-366-20-4
8-8. WTEC III TRANSMISSION CONTROLS INITIAL INSTALLATION (CONT)
NOTE
Install plastic cable ties as required.
Route WTEC III cab transmission harness with
connector J119 going through forward hole in
dashboard under kick panel, until in position
under left side dashboard.
(7) Position WTEC III cab transmission harness (11) in
dashboard (10).
NOTE
Perform steps (8) through (10) on vehicles
equipped with auxiliary panel.
(8) Route auxiliary panel cable assembly (9) through forward
hole in dashboard (10).
(9) Connect connector P108 (6) to connector J108 (5).
(10) Connect connector P210 (8) to connector J210 (7).
8-28
