TM 9-2320-366-20-4
8-6. WTEC II VEHICLE INTERFACE MODULE (VIM) REPLACEMENT/REPAIR (CONT)
d. Installation.
NOTE
If replacing WTEC II VIM and a WTEC II VIM
is not available, perform para 8-8.
(1) Connect connector PX33 (1) to WTEC II VIM (2).
(2) Tighten screw (3) in connector PX33 (1).
(3) Connect connector J116 (4) to WTEC II VIM (2).
(4) Tighten screw (5) in connector J116 (4).
(5) Install WTEC II VIM (2) on bottom of dashboard (6) with
two washers (7), washer (8), and screw (9).
(6) Install two washers (10) and screws (11) in WTEC II VIM
(2).
e. Follow-On Maintenance.
(1) Install kick panel (para 16-3).
(2) Connect batteries (para 7-57).
(3) Start engine (TM 9-2320-366-10-1).
(4) Road test vehicle (TM 9-2320-366-10-1).
(5) Shut down engine (TM 9-2320-366-10-1).
End of Task.
