TM 9-2320-366-20-4
This task covers:
a. Removal
c. Follow-On Maintenance
b. Installation
INITIAL SETUP
Equipment Conditions
Materials/Parts
Engine shut down (TM 9-2320-366-10-1).
Dispenser, Pressure Sensitive Adhesive Tape (Item
Batteries disconnected (para 7-57).
20, Appendix D)
Ties, Cable Plastic (Item 69, Appendix D)
Lockwasher (8) (Item 100, Appendix G)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix B)
Nut, Self-Locking (2) (Item 133, Appendix G)
a. Removal.
(1) Remove eight screws (1), lockwashers (2), and washers
(3) from control panel top cover (4).
Discard
(2) Remove two self-locking nuts (5), four washers (6), two
screws (7), and control panel top cover (4) from control
panel (8). Discard self-locking nuts.
NOTE
Tag electrical wires and connection points prior
to disconnecting.
Remove plastic cable ties as required.
(3) Loosen 17 screws (9) on terminal board (10) at positions
2, 3, 4, 6, 7a, 8, 9, and 10 through 19.
(4) Remove 17 electrical wires (11) on terminal board (10)
from positions 2, 3, 4, 6, 7a, 8, 9, and 10 through 19.
