TM 9-2320-272-24-2
Install wires (14) and (13) on starter (15) with new lockwasher (12) and nut (11).
28.
Install wires (9) and (10) on starter solenoid (17) with new lockwasher (8) and nut (7).
29.
Install wire (16) on starter (15) with new lockwasher (18) and nut (19).
30.
Install wire (4) on starter solenoid (17) with new lockwasher (20) and nut (21).
31.
Connect water heater hoses (1) and (5) on valves (3) and (6) and tighten two clamps (2).
32.
Install new lockwasher (24), three ground wires (28), and ground strap (25) on engine (23) with
33.
washer (27) and screw (26).
Route lead (29) over engine (23) and connect to temperature sending unit (22).
84.
Connect lead (43) to AC wire (42).
35.
NOTE
Ensure terminals are clean prior to installing wires.
Install accessory wire (33) on alternator (52) with new lockwasher (34) and nut (35). Tighten
36.
nut (35) 20-25 lb-ft (2-3 Nm).
Install negative wire (32) on alternator (52) with new lockwasher (44) and screw (41). Tighten
37.
screw (41) 82-102 lb-ft (9-12 Nm).
Install positive wire (36) on alternator (52) with new lockwasher (37) and nut (38). Tighten nut (38)
38.
45-55 lb-ft (5-6 Nm).
NOTE
Completely seal wires and inside of terminal cover with adhesive
sealant.
Install terminal cover (39) on alternator (52) with two new screw-assembled lockwashers (40).
39.
Install harnesses (47) and (49) and clamp (46) on engine (23) with screw (45).
40.
41.
Install harness (47) and clamp (50) on oil cooler housing (51) with screw (48).
Rotate alternator (52) upward and tighten screw (30).
42.
Tighten two screws (31) 35 lb-ft (47 N-m).
43.
4-80