TM 9-2320-272-24-2
3-385. BOOM FLOODLIGHT WIRE REPLACEMENT
THIS TASK COVERS:
b. Installation
a. Removal
EQUIPMENT CONDlTlON
APPLICABLE MODELS
Parking brake set (TM 9-2320-272-10).
M936/A1/A2
Battery ground cables disconnected (para. 3-126).
TOOLS
GENERAL SAFETY INSTRUCTIONS
General mechanic's tool kit (Appendix E, Item 1)
All personnel must stand clear during raising and
PERSONNEL REQUIRED
lowering of boom.
Assistant must remain at crane controls while
TWO
work is being performed beneath boom.
REFERENCES (TM)
TM 9-2320-272-10
TM 9-2320-272-24P
NOTE
Tag all leads for installation.
1.
Disconnect floodlight wire leads (7) from floodlight (8).
2.
Remove seven screws (6), clamps (5), and floodlight wire (1) from boom (2).
WARNING
Assistant must remain at crane controls until removal operation
is completed. Injury to personnel may result if boom control
lever is accidentally engaged while work is being done between
raised boom and swivel base.
All personnel must stand clear during hoisting operations. A
snapped cable, or swinging or shifting load, may result in injury
to personnel.
NOTE
Assistant will operate crane. Mechanic will continue with removal
operation after boom has been raised.
3.
Raise boom (2) to a 45-degree position (TM 9-2320-272-10).
4.
Remove remaining screws (6), clamps (5), and floodlight wire (1) from boom (2).
5.
Disconnect floodlight wire leads (3) from crane harness leads (4) and remove floodlight cable (1) from
vehicle.
WARNING
Assistant must remain at crane controls until installation
operation is completed. Injury to personnel may result if boom
control lever is accidentally engaged while work is being done
between raised boom and swivel base.
All personnel must stand clear during hoisting operations. A
snapped cable, or swinging or shifting load, may result in injury
to personnel.
3-946
