TM 9-2320-272-24-2
3-386. CRANE WIRING HARNESS REPLACEMENT (Contd)
WARNING
Assistant must remain at crane controls until removal
operation is completed. Injury to personnel may result if boom
control lever is accidentally engaged while work is being done
between raised boom and swivel base.
All personnel must stand clear during hoisting operations. A
snapped cable, or swinging or shifting load, may result in injury
to personnel.
Raise boom (5) to a 45-degree position (TM 9-2320-272-10).
1.
Spread out crane harness (14) on vehicle along general lines of installation.
2.
Thread gondola floodlight wire (18) through side plate (4) and connect leads (2) to floodlight (1).
3.
Connect crane harness leads (17) to swivel leads (16).
4.
Connect crane harness leads (6) to floodlight wire leads (7).
5.
Thread oil reservoir floodlight wire (11) through side plate (13) and connect leads (9) to oil reservoir
6.
floodlight (10).
Install oil reservoir floodlight wire (11) on side plate (13) with three clamps (12) and screws (8).
7.
Install crane harness (14) on turntable (22) and side plates (4) and (13) with six clamps (15) and
8.
screws (21).
Install gondola floodlight wire (18) on gondola (20) with three clamps (3) and screws (19).
9.
Lower boom (5) (TM 9-2320-272-102
10.
3-950